In need of help with wiring diagram for subwoofers

That amp is ok with 2 ohms I believe. If each of your subs are single voice coil 4 ohms then wire them in parallel and you'll have two ohms.

That means positive on your amp goes to the positive on each of your subs and the negative to each of the negatives on your sub.

Amp + to sub 1 +and sub 2 +

Amp - to sub 1 - and sub 2 -

VS series. which would be:

Amp +to sub 1 +,

Sub 1 - to sub 2 +,

Sub 2 - to amp -,

Does that help?

 
If it's 4 ohms per coil just wire the two coils on the speaker as either 2 or 8 ohms by series or parallel wiring, then do the opposite from the amp to both subs. Will give you a 4 ohm total. That's your only option if they are 4 ohms pets coil as that amp I doubt is 1 ohm stable.

If the coils are 2 ohms, you can wire it the same way and end up with a 2 ohm load.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Try again on the attachments/pictures. They didn't load. Not exactly sure on the wiring, but you can buy an adapter harness that goes from your...
1
887
No not in this situation.PM sent for proper use of the Y splitters for this situation
34
5K
Sure, 600 volts, yep. If you’re trying to launch the subwoofer cones to the moon! And, that’s if they don’t just vaporize first!
34
4K
Is that 1000w max? Don't expect to be able to bridge a 1000w amp at 2 ohms and get 500w x 2ch. I'm pretty sure you can't with that amp, for...
1
1K

About this thread

Elpolloloco16

Junior Member
Thread starter
Elpolloloco16
Joined
Location
Kansas City Kansas
Start date
Participants
Who Replied
Replies
5
Views
481
Last reply date
Last reply from
ashren315
1716436519534.png

Doxquzme

    May 22, 2024
  • 0
  • 0
tip.gif

1aespinoza

    May 22, 2024
  • 0
  • 0

New threads

Top