If wiring two amps to the trunk, is it recommended to run seperate 0 gauge wires?
- Thread starter jeeper2269
- Start date
- Replies 3
- Views 507
-
3Participant count
-
Participant list
-
jeeper2269
LosIsATool
5,000+ posts
CarAudio.com Veteran
Yes. If it's good 1/0 it will easily support 3000 watts rms. in most cases more
keep_hope_alive
Premium Member
Acoustics Engineer
yep, just plan on a fused distribution block to split the wiring to each amp.
OP
jeeper2269
10+ year member
Senior VIP Member
- Thread Starter
- #4
Thank you
Activity
No one is currently typing a reply...
Similar threads
Just ignore Red...he's wealth of useless to dangerous advice...all without knowing what he's talking about
- Started by txjeep
- Wiring, Electrical & Installation 2
- Started by Bigfella1978
- Wiring, Electrical & Installation
You can try that Seat Bolt for a ground location. Remove all paint down to Metal. Place a Washer then One amps ground Ring terminal(copper..sand...
- Started by threebills
- Wiring, Electrical & Installation
The wiring harness adapter is less than $10 online. It makes everything 10x easier. You just wire your new stereo to the adapter outside of the...
- Started by Darrell Robinson
- General Car Audio
Ive doubled up 12 ga many times for sub wiring.. even 14 ga for speaker wiring. Its OFC and it should do great and save you some money since you...
- Started by Mr FaceCaser
- Wiring, Electrical & Installation
About this thread
New threads
-
Vintage Lanzar 12 inchHi Has anyone got the data sheet for an old Lanzar sub? I...
- Started by Mmatt
- Replies: 0
-
-
Has anyone used DataSat Amplifiers?I have a DataSat home theater system in my media room and I...- Started by Steve IZZI
- Replies: 2
-
I need Help picking the right amplifierAny recommendations for a 5 channel amp that has a 4 ohm f/r...- Started by Zach H
- Replies: 12
-
Advice: will I have enough high frequency quality / volume?I am planning out a system for my ‘04 Ram 1500 with the...- Started by Adam LaFountain
- Replies: 8