HUs and DSPs... General knowledge...

  • 3
    Participant count
  • Participant list

HardcoreBob

Senior VIP Member
188
0
Dallas
If you have a DSP that covers eq/xover/ta etc., all that stuff is to unnecessary and unwanted in your HU, correct?

Not “necessarily” unwanted, but you wouldn’t use the HU settings if you had a good DSP right?

Sent from my iPad using Tapatalk

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Well, they don't sell the CDTs so there is that... I sold electronics (audio) years ago, in a very hi-end environment. one of the emphasis they...
5
882
time alignment is not the same as volume. Time alignment is usually only needed when you have an amp or multiple amps, and one has a delay. I...
1
801
Looks like it's wire it either 4 or 8 ohm 🤔
4
828
Okay. Thank you so much! I will run individual power / ground wires to each amp. If the front of the car has no dedicated spot for tweeters, what...
2
865
You will need distribution blocks for the amps I would run 0 gauge to the blocks and 4 gauge to the amps. For the head unit I would us one that...
1
913

About this thread

HardcoreBob

Senior VIP Member
Thread starter
HardcoreBob
Joined
Location
Dallas
Start date
Participants
Who Replied
Replies
2
Views
474
Last reply date
Last reply from
Jcsaudio
IMG_0503.jpeg

DEW123

    May 7, 2024
  • 0
  • 0
IMG_0489.jpeg

DEW123

    May 7, 2024
  • 0
  • 0

Latest topics

Top