HU will not power on

jakeup

Junior Member
I just got my jeep broken into and the stereo stolen. They cut the harness so i have no where to plug my new deck into. I went to installdr.com and got the wiring diagram for my jeep and matched up the wires to my new deck. I am SURE I hooked everything up right but it wont power on.

Any ideas of what I can check for?

Thanks

Jake

 
if u have ur constant 12v and acc. wire and ground correct then i see no reaosn y it would turn on. check ur radio fuse in ur fuse box and if the fuse is fine then take the radio out and run it directly to the battery. if the radio turns on the ur wires might be fukked up and if it doesnt ur radio is shot...

 
The raido fuse is fine. I also ran a wire dirrectly to the battery and still nothing happened.

Is it possible that the wiring diagram is not 100% accurate? I tried switching the ignition and battery wires around and I heard the deck turn on this time but there was no display.

 
maybe while installing ur adio ur shorted and the radio fuse popped check that but heas the wires of ur car

Constant 12V+ Red/White

Switched 12V+ Purple/White

Ground Black

Illumination Blue/Red

Dimmer Red/Black

Antenna Trigger Purple/Orange

Antenna Right Front

Front Speakers 5 1/4" Doors

Left Front (+) Gray

Left Front (-) Yellow

Right Front (+) White/Red

Right Front (-) Brown/Red

Rear Speakers 5 1/4" Rear Deck

Left Rear (+) Gray/White

Left Rear (-) Brown/White

Right Rear (+) White/Black

Right Rear (-) Brown

 
i did something stupid....when i ran a wire to the battery i connected it to the ignition wire instead of the power wire. so i tried it with the power wire this time and it worked.

so i have another question now.... where can i get power from?? somewhere in the fuse box?

 
ur contant on the radio harness goes to red/white wire of ur car wires

ur accessory wire on the radio harness gores to the purple/white on ur car wires

ground is ground

and if u have amps and u need remote turn on tap the radio fuse and run it to ur amps if more than 2 amps i would use a relay...

 
Hey thanks a lot for your help man.

The only problem now is that whenever i turn the car off and back on again all of my settings re gone. like the time and raido stations, things like that. is there a way to fix that?

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

jakeup

Junior Member
Thread starter
jakeup
Joined
Location
Pleasanton
Start date
Participants
Who Replied
Replies
14
Views
857
Last reply date
Last reply from
saturnspl1991
IMG_20260515_202650612_HDR.jpg

sherbanater

    May 15, 2026
  • 0
  • 0
IMG_20260515_202732887_HDR.jpg

sherbanater

    May 15, 2026
  • 0
  • 0

New threads

Top