How to wire two dual 4 ohm subs to 2ohms?

I guess the only way to really get a 2 ohm load from a pair of dual 4 ohms is to use 2 amps. Each one running 2 ohms. It's more complicated this way and kinda pointless if you ask me. You're better off running at 1 ohm with one amp though as it's the best bang for the buck. If your amp is not 1 ohm stable, then get one that is. Otherwise getting a lot of power at 4 ohms is expensive. Some of the old school amps you could bridge at 4 ohms though, which is just as good.

 
You can short one of the VC's on each sub (jumper + to - on one VC and don't connect it to anything else). Then you can wire the other VC from each sub in parallel to get a 2 ohm load.

IF you do this, then derate your power by ~75% to be safe.

I ran a JL dual 4ohm VC sub like this for years without any issues at all. The theory behind shorting the unused VC is that it increases damping so the sub & enclosure behave roughly the same way it did with 2 VCs wired.

There is a paper written about the theory on this somewhere - I will look for the link later.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

Thread starter
GuysIGotThis
Joined
Location
Ottawa, ON, CA
Start date
Participants
Who Replied
Replies
7
Views
1,946
Last reply date
Last reply from
Jepalan
IMG_20260516_193114554_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0
IMG_20260516_192955471_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0

New threads

Top