How to wire two amps?

[jeeper2269 10+ year member]

I am running a single 12" Fi sub on my JBL. BP1200.1

and a set of boston pro series 6.5 components in the front.

I have the following amps,

kicker zx350 for the bostons

and the jbl amp running the single 12

how do I wire them off a stock deck 2006 Toyota Tacoma 4x4.

Click to read more...

 

[Einzee 10+ year member]

You will need what I call Hi to Low converters. They are electronic devices that convert your radio outputs to the RCA style plugs.

Any signal that is amplified is considered a "Hi" output. These devices take the Hi output signal and lowers it down to an acceptable level for your "Low" inputs on your amps.

 

[blackbonnie 5,000+ posts]

with a loc (line output convertor)

 

[Einzee 10+ year member]

with a loc (line output convertor)

^^^^ Thats what I meant. Thx //content.invisioncic.com/y282845/emoticons/wink.gif.608e3ea05f1a9f98611af0861652f8fb.gif

 

[blackbonnie 5,000+ posts]

no problem, i knew thats what you were talking about

 

[jeeper2269 10+ year member]

okay, but how do I hook the remote wire up?

 

[Worlddre 5,000+ posts]

you find a switched 12v source in toyotas its the thin gray wire in the radio harness or you can go to the ignition harness

 

[jeeper2269 10+ year member]

I love the internet... Thanks guys. Much appreciated.

 

[mit42ls 10+ year member]

You might wanna check out Tundrasolutions.com ...

They have a lot of info their and probably some wiring diagrams for the Tacoma's stereo system. I know on my Tundra there was a factory amp so the speaker signal comming off my head unit was actually low level already. All I had to do then was solder/splice some RCA ends on them instead of using a LOC, w/c I did by mistake.