how to wire to 2 ohm load?

[brybry354 10+ year member]

do you do it with the speaker wire or the RCA cables?

how do you get these subs:http://www.sonicelectronix.com/item_8456_Kicker+07C104.html

to put out a 2 ohm load with this amp:http://www.sonicelectronix.com/item_6750_Kicker+ZX300.1.html

using this wiring kit:http://www.knukonceptz.com/productDetail.cfm?prodID=KOL-AK8

what do you do to wire the subs to a 2 ohm load?

use the RCA cables or speaker wire?

Click to read more...

 

[jdc753 10+ year member]

are you planning on running a pair of those subs to that amp?

Here you go.

and for future reference if you go to http://www.rockfordfosgate.com and check out the lower right hand corner you will see a link for Woofer WiringWizard

The speaker wire included in that amp kit should work fine for those subs.

 

[2004SRT4 10+ year member]

Nither you use the ground wire.

Yup..I'm kidding..the speaker wires, it's the load going from the amp to the subs.

 

[brybry354 10+ year member]

yeah im powering 2 subs with the amp.

so i just split the ends of the (+) and (-) speaker wires and tie each end of the (+) or (-) to one of the subs?

 

[n2audio 5,000+ posts]

typically you'd just connect two wires each to the amp's (+) and (-) speaker outputs, and run a pair to each speaker.

You could also run a (+) and (-) from the amp to one sub, and run another set from the first sub to the next.

Physically they're different, but electrically they're all the same connection.

 

[brybry354 10+ year member]

well would my way work?