im installing a stereo in my travel trailer. the highs consist of 4 coax speakers in the trailer, and 2 outdoor speakers that will be mounted on the outside when the trailer is parked. i want to run all 6 of these speakers off of a kicker ZX350.4. the 2 outdoor speakers will have the 2 rear channels all to themselves. however, i want to run the 4 coax speakers (4 ohm) that are inside the trailer off of the front 2 channels. i will wire them as pairs in parallel to get two 2 ohm loads. this amp will do 60w @ 4 ohms or 90w @ 2 ohms. i realize i will loose my fading either front/rear or left/right.
so, how do i wire these two channels? do i wire them as i normally would (R+ R- / L+ L-), and the amp will just push out more power because it is hooked to a lower impedance.
or do i bridge the two front channels? (R+ L- / R- L+)
so, how do i wire these two channels? do i wire them as i normally would (R+ R- / L+ L-), and the amp will just push out more power because it is hooked to a lower impedance.
or do i bridge the two front channels? (R+ L- / R- L+)
