I recently purchased a 2005 Mustang GT which came with a shaker 1000 system. The original radio and 4 amps in the trunk were replaced with aftermarket units. The amplifier going to the subwoofer in the trunk is not connected to the subwoofer. It is connected to the radio and has power. The amp is an Alpine MRP-M450 Mono subwoofer amplifier. There are only 2 wires coming from the amp (speaker output) to connect to the subwoofer. I was wondering how to connect it to the subwoofer since the subwoofer has two wire harness connections. Any assistance would be greatly appreciated.
-
1Participant count
-
Participant list
Activity
No one is currently typing a reply...
Similar threads
Use this for the PB bypass.
- Started by HandsomeSteve
- General Car Audio
Sweet!!!!!
- Started by ikpthegame
- Wiring, Electrical & Installation 2
Drill a hole and use the proper protective split loom and hole grommets to keep the outer speaker jacket from knicks and cuts, give just enough...
- Started by Red Dog
- Wiring, Electrical & Installation
It mostly comes down to weight. You can have a super lightweight cone, soft suspension and aluminum coil on a sub and you pretty much get a pro...
- Started by MrButtersworth
- Subwoofers
Yes . Until i get a 3.5 or 4 inch mid
- Started by Bass so loud it HZ
- General Car Audio
About this thread
Latest topics
-
-
-
-
-
Jeep center console sub install issues.
- Started by vlusardi
- Replies: 1