how to wire 2 dvc to 1 ohm in a ported box

[ecksman 10+ year member]

i want to wire my 2 4 ohm l7's to one ohm, i'm fairly new to this and tried looking at some diagrams but ran into a problem i realized that mysubs are blocked off from each other

Click to read more...

 

[loud-n-low 10+ year member]

run positive and negative from side of the box to the other,then bridge it to the amp..that will be 2 ohm mono

 

[RandyJ 10+ year member]

ill draw up a diagram right quick.

 

[ecksman 10+ year member]

but i want 1 ohm

 

[loud-n-low 10+ year member]

single 4 ohm subs?

 

[dustinr 10+ year member]

run positive and negative from side of the box to the other,then bridge it to the amp..that will be 2 ohm mono

I thought 2 4ohm dvc could only be ran to 4 & 1 ohm

 

[ecksman 10+ year member]

thanks

 

[loud-n-low 10+ year member]

2ohm mono is same output as 1 ohm stereo

 

[dustinr 10+ year member]

http://rockfordfosgate.com/rftech/wiringwizard.asp?WoofQty=2+woofers&WoofImp=Dual+Voice+Coil+-+4+ohms+x+2&image.x=14&image.y=11

 

[ecksman 10+ year member]

2 4 ohm dvc l7's

 

[bonesninja 5,000+ posts]

which amp?

 

[loud-n-low 10+ year member]

if their dual 4 ohm subs you would be running at 1 ohm mono,or .5 ohm stereo

 

[loud-n-low 10+ year member]

if each sub is SINGLE 4 ohm, it would be 2 ohm mono,which will put out amps 1 ohm power rating,or is your amp a mono block?

 

[ecksman 10+ year member]

hifonics brutus 1605d

 

[bonesninja 5,000+ posts]

are there 2 sets of speaker connections? if so just wire each sub to 2 ohms then connect one sub to each set of connections.