How do i cross thse speakers?

[basscort2009 5,000+ posts]

ok so i have these door pods with these speakers (see pic below)

the tweeters are ran together in parallel to 4 ohms.

the mids are ran together at 2 ohms.

amp is a crossfire bmf 600.2 so i just have mids on one channel and the tweets on another channel.

i have all speakers running active to the amp.

MY QUESTION is what xover do i use to cross the tweets because the amp only has 1 xover freq knob so i just have it at its highest (250 htz) and then cross the tweets on the HU at 4khtz.

i want to turn the xover on the amp down so i can let my mids do more work on the bass side but im scared if i turn it down it will blow the tweeters being set too low.

PLEASE give me some insight

Click to read more...

 

[fasfocus00 5,000+ posts]

put a non polar cap inline with the tweeters

 

[basscort2009 5,000+ posts]

what value cap would i need?

 

[fasfocus00 5,000+ posts]

chart_index

this should help

 

[basscort2009 5,000+ posts]

so if i want it to play 1500 htz and higher only i get a 18uf cap? also i just make it inline with the tweeter pos. wire right? i see on that chart they have some other junk going on that idk about