Hifonics Amps

Many people on caco report that there's a low frequency cutoff with the hifonics amps like below 28hz. I've experienced it myself as well, a simple switch over to a korean board and the low lows came out in full force, before with the hifonics, it was like several db of attenuation.
Never heard of this.

One of my friends had a DD 9515 at .5 ohm on a 2400 and it was a low end monster. Ran with the stock alternator and just an extra battery in the rear. One run of CCA 1/0 front to back

 
This is the fz2600

f9df1d64df700c026d6cb2dd2664e316.jpg


Sent from my iPhone using Tapatalk

 
FSD 2600 for 332$Brutus elite 2500.1 for 375$

for cheaper than hifonics, you can get an amp that easily does 100 watts more than rated certified dyno numbers and 3k with uncertified and 3.6k with dynamic. You still gonna defend hifonics crap after that? Price to performance, ratio is SH*T with hifonics unless you get for dirt cheap used but you can get proper korean board amps used as well.

compared to that brutus elite that barely passed by the inch of its skin with dynamic numbers and flubbed the other two numbers on steve meade's test which one do you really think is good for the money?

https://www.youtube.com/watch?v=_Qr8uhLD5tAhttp://www.youtube.com/watch?v=_Qr8uhLD5tA
Ive already said the elite is **** ^^^^ look at the other page

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Yep, at the amplifiers. I get the same 14.7 volt reading when they cutoff too.
12
1K
Pull it and test it at the battery post. Simple Power up test to verify if it powers up fine out of protect mode. if it does then Id be checking...
3
1K
I have a Gemeni VII, Heucules VII, Pluto VII, and a Vulcan VII left out of a massive slew of VII and VIII series. They still work Excellent...
5
3K
  • Locked
COMPLETED Hifonics Plato III
Yes, they are painted. The cover is very easy to take off and repaint to whatever color of choice to match the install.
2
1K
How I would approach it is install your new amplifier and start using it. Install a voltage gauge and if you see your voltage lowering then add...
4
265

About this thread

AcuraTL

Member
Thread starter
AcuraTL
Joined
Location
Burnaby
Start date
Participants
Who Replied
Replies
54
Views
4,423
Last reply date
Last reply from
bgowdy
Screenshot_20240524_202505_Samsung Internet.jpg

winkychevelle

    May 24, 2024
  • 0
  • 0
Screenshot_20240523-151806.png

1aespinoza

    May 23, 2024
  • 0
  • 0

New threads

Top