Fun project? -6- budget 10's..

[Sleeklsc 5,000+ posts]

Dickin' around at work and thought this could be a fun project. 6 of these sealed. 3 blowin up into my rear deck hole and 3 firing toward's the trunk opening. Totally f'n ghetto but could make for a fun money wasting project.

Watchuthink?

10" Single 4 Ohm PS Series Subwoofer

Power Handling:

Peak: 450 watts

RMS: 225 watts

Impedance: Single 4 ohm

Ribbed DDC-treated paper cone woofer

2-Layer roll treated foam surround

Precision stamped steel basket with aeroventing

Progressive flat spider

One piece EVA closed cell gasket

Extended and vented pole motor assembly

Industry-standard cutout patterns

2" BASV voice coil

110oz. Magnet

Frequency response: 33-500 Hz

Sensitivity: 90 dB

Click to read more...

 

[Mitch86 5,000+ posts]

How much are they?

 

[Sleeklsc 5,000+ posts]

225~ shipped for all 6 of em'.

 

[Sleeklsc 5,000+ posts]

Or 300 shipped for the dvc's.

The svc4 would wire down to .67, which would work for me.

 

[Mitch86 5,000+ posts]

I'm sure it would get down for 234 bucks if done right.

 

[Sleeklsc 5,000+ posts]

I'm sure it would get down for 234 bucks if done right.

Sealed they rec .5-.9cu ft each. Off the top of my head that would be roughly 4.2 cuft @ .7cf each.

 

[Mitch86 5,000+ posts]

Sounds good. How much power ya got to throw at them?

 

[Sleeklsc 5,000+ posts]

As of right now 1400rms@1. I'll be above 1 after rise so i'm not to worried about that. Though I see a modded 1501d in my future.

 

[Sleeklsc 5,000+ posts]

nm

 

[kramer_212 10+ year member]

hey those powerbasses are ok, and a great price. most likely perform better than you would expect i know when i heard some of the 12s i was impressed.

 

[The_Grimy_One 10+ year member]

Just do it!

 

[DoesDad 10+ year member]

Should be loud! I'm kind of curious as to how the PB's will do. Was going to go with those in my daughter's car. Heard they get down for budget drivers. You going to do a build log for all us bored fockers to look at?

 

[skylineTT 10+ year member]

are you gonna put it in one of those sealed prefab boxes? lol

 

[Sleeklsc 5,000+ posts]

After much thought I might be leaning away from them. I forgot to figure in sub disp and bracing thus not giving me enough room for 6. 4 or 5 is still an option. For the price it's kinda hard to beat. It's this idea or 3 10" or 12" Sundown E series sealed. All I know at this point is I want to run 3 or more sub's. So many f'n options.

 

[Sleeklsc 5,000+ posts]

are you gonna put it in one of those sealed prefab boxes? lol

It would be sealed but i'd build it to my spec.