I have a Zapco Competition Series C2K for sale. I am looking for $250 shipped to your door for it. I have all the original packaging, birth sheet, and manual.
I also have a 20ft symbilink cable for it. The amp is in perfect condition with under 50 hours of play. it does have minor scratches on it, but they are only visible from close up and do not affect performance. My paypal account is bdavid17@comcast.net.
This amp is perfect bridged for a subwoofer, or it shines as an amp for a good set of speakers.
Specs:
Stereo, 4 ohms: 2 x 50 Watts
Stereo, 2 ohms: 2 x 100 Watts
Bridged, 2 ohms: 1 x 400 Watts
T.H.D. + Noise:
Other Information:
2-Channel High Current Amplifier with Dual Crossover Dual Outputs Stable into 1 Ohm Stereo Loads
-Chassis design allows infinite customization options by replacing slide-in trim panels to personalize any installation
-SymbiLinkâ„¢ Balanced Technology provides up to 16 voltsof balanced input for the cleanest, quietest signal possible
-Pre-clip and output clip indicators to maximize performance settings
-Symmetrical, discrete power amplifier circuitry
-Fuse, short circuit, high temperature, DC offset, and over voltage protection
-Dual color LED for power and protection indications
-25-amp High Current Bi-Polar output devices
-50-amp MOSFET switching devices
-Optically isolated power supply
-Gate Drive Boost maximizes power supply efficiency and improves overall performance
-Very high damping for excellent speaker control
-Surface Mount Technology w/1% resistors,
precision capacitors, and massive ground planes
-High Current design allows 2 ohm mono loads for
use as a bass amp with low Z woofer systems
-Four layer PC board with heavy 2 oz copper
-Variable electronic crossovers (Input & Aux Out)
-Pass-through output
-Sub-sonic filter for speaker protection
-Switch for use as stereo, single L ch. or R ch. bridge
-L+R sum mono for use as a bass amp
-Dual cooling fans allow any mounting position
here are some pics
I also have a 20ft symbilink cable for it. The amp is in perfect condition with under 50 hours of play. it does have minor scratches on it, but they are only visible from close up and do not affect performance. My paypal account is bdavid17@comcast.net.
This amp is perfect bridged for a subwoofer, or it shines as an amp for a good set of speakers.
Specs:
Stereo, 4 ohms: 2 x 50 Watts
Stereo, 2 ohms: 2 x 100 Watts
Bridged, 2 ohms: 1 x 400 Watts
T.H.D. + Noise:
Other Information:
2-Channel High Current Amplifier with Dual Crossover Dual Outputs Stable into 1 Ohm Stereo Loads
-Chassis design allows infinite customization options by replacing slide-in trim panels to personalize any installation
-SymbiLinkâ„¢ Balanced Technology provides up to 16 voltsof balanced input for the cleanest, quietest signal possible
-Pre-clip and output clip indicators to maximize performance settings
-Symmetrical, discrete power amplifier circuitry
-Fuse, short circuit, high temperature, DC offset, and over voltage protection
-Dual color LED for power and protection indications
-25-amp High Current Bi-Polar output devices
-50-amp MOSFET switching devices
-Optically isolated power supply
-Gate Drive Boost maximizes power supply efficiency and improves overall performance
-Very high damping for excellent speaker control
-Surface Mount Technology w/1% resistors,
precision capacitors, and massive ground planes
-High Current design allows 2 ohm mono loads for
use as a bass amp with low Z woofer systems
-Four layer PC board with heavy 2 oz copper
-Variable electronic crossovers (Input & Aux Out)
-Pass-through output
-Sub-sonic filter for speaker protection
-Switch for use as stereo, single L ch. or R ch. bridge
-L+R sum mono for use as a bass amp
-Dual cooling fans allow any mounting position
here are some pics
