Sold FS: Pioneer DEQ 7600, Cadance CWM6, Kenwood 9102d & 7202

sporty_drew
10+ year member

Just here...
Rating: 100%
1 0 0
All offers accepted thru PM

Well I have a few things forsale.

Pioneer DEQ 7600 Processor ~Sold

Details:

* 15-band digital EQ offers +/- 15dB gain, 3 user presets and 5 factory presets (Rock, Pop Vocal, Jazz, Hip Hop)

* 5 soundfields (Studio, Club, Jazz Club, Concert Hall, Stadium)

* 4-mode Listening Position Selector (Front Left, Front Right, Front, All)

* 1 set of preamp inputs

* 3 sets of preamp outputs (Front, Rear, Subwoofer)

* selectable low-pass crossover for subwoofer output at 50, 80 and 125 Hz with an 18 dB/slope

* 15-band spectrum analyzer

* memory backup retains settings for 3 days if your battery dies or is disconnected

* signal-to-noise ratio 91 dB

* THD 0.01%

* 7-3/16"W x 2-1/8"H x 6-3/16"D

P1010084.jpg


P1010081.jpg


Cadance CWM6 and crossovers (no tweets)

I'm not sure what to ask for, so lets say trades and i'm open to trade offers.

P1010080-1.jpg


P1010079-1.jpg


P1010078-2.jpg


P1010077-3.jpg


Kenwood 9102d ~$130.00 Shipped usps

mono subwoofer amplifier

500 watts RMS x 1 at 4 ohms (850 watts x 1 at 2 ohms)

variable low-pass filter (50-200 Hz at 24 dB per octave)

variable bass boost (0-18 dB at 40 Hz )

subsonic filter (15/25 Hz, 18 dB/octave )

top-mounted controls

Class D design

CEA-2006 compliant

speaker- and preamp-level inputs

preamp outputs

fuse rating: 30A x 2

4-gauge power and ground leads recommended — wiring and hardware not included with amplifier

15"W x 2-7/16"H x 11-3/4"D

Kenwood 7202 ~ $120.00 Shipped usps

two-channel car amplifier

150 watts RMS x 2 at 4 ohms (230 watts x 2 at 2 ohms)

460 watts RMS x 1 bridged output at 4 ohms (4 ohm stable in bridged mode)

high-pass (12 dB per octave) and low-pass (24 dB per octave) filters variable from 50 to 200 Hz

selectable bass boost (0-18 dB at 40 Hz)

cooling fan

MOSFET power supply

Tri-way capable (Tri-Way Crossover required)

CEA-2006 compliant

preamp- and speaker-level inputs

preamp outputs

fuse rating: 40A x 1

8-gauge power and ground leads recommended — wiring and hardware not included with amplifier

15"W x 2-7/16"H x 11-5/16"D

P1010095.jpg


I'm open to offers thru pm's and i'll consider all trades.

 
I'm not familiar with the mmats. Whats the model number on that? I'll think about a 15 to mess around with since i can't use them in my setup Thanks

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

sporty_drew

10+ year member
Just here...
Thread starter
sporty_drew
Joined
Location
Iowa
Start date
Participants
Who Replied
Replies
28
Views
1,790
Last reply date
Last reply from
sporty_drew
IMG_20260516_193114554_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0
IMG_20260516_192955471_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0

New threads

Top