Finally got the TSP's for my custom sub

  • Thread starter Torquem
  • Replies 0
  • Views 402

Torquem
10+ year member

Member
I finally got around to getting TSP's pulled on the sub I had built. Not sure what enclosure to go with just yet. All I know is that I want it to hit looow and have a decently flat response up to about 90 hz or so.

Here's the stats

The sub

3hp TC motor

Eclipse sw8000 basket

single medium spider

single 3 ohm coil - 2.875" winding width

High roll stitched rubber surround

heavy paper cone with aluminum cap

TSP'S

Vas drive current - 3181.82uA

Revc - 3.5740

Fs - 28.9758

Zmax - 37.7847 ohms

Qes - 0.6792

Qms - 6.5016

Qts - 0.6150

Le - 2.1598 mh (at 1Khz)

Diam - 247.6500mm (9.7500 in)

ConeArea - 48168.8790 mm^2 (74.6619 in^2)

Vas - 51.4815 L (1.8181 ft^3)

BL - 13.5258 N/A

Mms - 190.9724 g

Cms - 157.9784 uM/N

Kms - 6329.9810 N/M

RMS - 5.3477 R mechanical

Efficiency - 0.1778 %

Sensitivity - 84.4983 dB @ 1W/1m

Sensitivity - 87.9976 dB @ 2.83Vrms/1m

custom.jpg


custom2.jpg


 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

Torquem

10+ year member
Member
Thread starter
Torquem
Joined
Location
Apex, NC
Start date
Participants
Who Replied
Replies
0
Views
402
Last reply date
Last reply from
Torquem
IMG_20260515_202650612_HDR.jpg

sherbanater

    May 15, 2026
  • 0
  • 0
IMG_20260515_202732887_HDR.jpg

sherbanater

    May 15, 2026
  • 0
  • 0

New threads

Top