240.00 shipped to the cont usa.....no trades
this is a US Amps Merlin md23 . it's in near mint condition, it has a small scratch on the top. i give it a 9 out of 10 for condition, and a 10 out of 10 for functionality...it works 100% and sounds great! it's ready to pound some subs or a crapload of mids and tweets..lol...... has a built in high/full range/low crossover and a subsonic filter, and a 12db bass boost gain
the amp comes with the box, manual and a remote bass knob!
i have heard you can run the amp at 2 ohm bridged with a good electrical, but i don't advise you do that...//content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif
here are the specs:
300 x 2 rms @ 4 ohm
460 x 2 rms @ 2 ohm
960 x 1 rms @ 4 ohm bridged
total harmonic distortion 0.03%
s/n ratio : 105db
freq resp.: 10hz-50khz
damping factor : 600
fuse rating: 3 - 30amp
power voltage range : 12v - 16v
high current MOSFET devices
protection: thermal,overload,short circuit,dc offset .
input sensitivity: 200mv - 6.0v
multiple bypass capacitors on the incoming 12v supply
time delay turn on
pics!
pic of it powered up and hooked up to my 12's in my room bumpin..
i dont have a use for this amp. it is just collecting dust. i already have my bass amp already...
this is a US Amps Merlin md23 . it's in near mint condition, it has a small scratch on the top. i give it a 9 out of 10 for condition, and a 10 out of 10 for functionality...it works 100% and sounds great! it's ready to pound some subs or a crapload of mids and tweets..lol...... has a built in high/full range/low crossover and a subsonic filter, and a 12db bass boost gain
the amp comes with the box, manual and a remote bass knob!
i have heard you can run the amp at 2 ohm bridged with a good electrical, but i don't advise you do that...//content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif
here are the specs:
300 x 2 rms @ 4 ohm
460 x 2 rms @ 2 ohm
960 x 1 rms @ 4 ohm bridged
total harmonic distortion 0.03%
s/n ratio : 105db
freq resp.: 10hz-50khz
damping factor : 600
fuse rating: 3 - 30amp
power voltage range : 12v - 16v
high current MOSFET devices
protection: thermal,overload,short circuit,dc offset .
input sensitivity: 200mv - 6.0v
multiple bypass capacitors on the incoming 12v supply
time delay turn on
pics!
pic of it powered up and hooked up to my 12's in my room bumpin..
i dont have a use for this amp. it is just collecting dust. i already have my bass amp already...
