Shawnlh
10+ year member
Junior Member
(Rear speakers should never be allowed to operate in full range unless you are going for the THX or Dolby Digital AC-3 theater surround sound setup. If you have a separate subwoofer, band-limit the signal going to the rear speakers to approximately between 200Hz and 3kHz.
To wring out some negative side effects, the rear speakers should be in mono. Put the two speakers in series and bridge them across the amplifier.
You are going to be running it low-volume, band-limited and in mono, (it is important that you keep it low-volume, band-limited and in mono). )
I read this and thought I'd give it a try, but I would like to see what you think first.
Reason is, I drive an '03 Dakota ext. cab (previously had a '93 Dak. ext. cab) and I noticed that the rear quarters produce real nice midbass. Even with 6.5's in the doors and fully dynomatted, the rear speakers midbass was much better. So, maybe I'll give this set-up a shot if I here enough positive feed back.
here's a link to where I got the info:
http://wickedcases.com/caraudio/rearfill.html
To wring out some negative side effects, the rear speakers should be in mono. Put the two speakers in series and bridge them across the amplifier.
You are going to be running it low-volume, band-limited and in mono, (it is important that you keep it low-volume, band-limited and in mono). )
I read this and thought I'd give it a try, but I would like to see what you think first.
Reason is, I drive an '03 Dakota ext. cab (previously had a '93 Dak. ext. cab) and I noticed that the rear quarters produce real nice midbass. Even with 6.5's in the doors and fully dynomatted, the rear speakers midbass was much better. So, maybe I'll give this set-up a shot if I here enough positive feed back.
here's a link to where I got the info:
http://wickedcases.com/caraudio/rearfill.html
