Deck cuts out when I slow down

I got a Blaupunkt Austin CD41 from my dads car, and after searching for the right wiring harness, i finally found it at radioshack, they said it would be 45 dollars for them to install it but i cant afford that, so i did it my self. I put in the harness then attached the wires color accordingly.Well, it was hooked up and working well, when the fuse blew just a mile down the road. I got a new fuze, and now it works only when i am driving at a good pace, then shuts off when i slow down for turns and such. It only works when the lights are on. and doesn't work in my ACC position on the ignition.

Any help would be very appreciated.

Thanks

 
Sounds like it is incorrectly wired, or something is shorting out. How did you connect the wires together..electrical tape? crimp connectors? Are any wires exposed?

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

bumpin88nova

Junior Member
Thread starter
bumpin88nova
Joined
Location
Turners Falls, MA
Start date
Participants
Who Replied
Replies
3
Views
431
Last reply date
Last reply from
NhustlaR
IMG_20260515_202650612_HDR.jpg

sherbanater

    May 15, 2026
  • 0
  • 0
IMG_20260515_202732887_HDR.jpg

sherbanater

    May 15, 2026
  • 0
  • 0

New threads

Top