Big-Cat
10+ year member
Registered User
I was just looking at the RE XXX, and i clicked on the T/S Parameters. I don't know much about this stuff, but i think the Xmax is how far the sub cone thing moves up and down, and the measurement is each way, right? and if i'm correct, the more air that's moved from the cone moving more, the more bass is put out?
"XXX 12" Quad 1.2ohm VC Info Sheet
TS Parameters
Fs 34.4Hz
Re 1.17 ohms
Qms 5.19
Qes 0.49
Qts 0.45
Vas 31.6 liters
Sd 480 cm^2
RMS 1600w
Xmax 38mm //content.invisioncic.com/y282845/emoticons/eek.gif.771b7a90cf45cabdc554ff1121c21c4a.gif
Dimensions
A 12.5in
B 11.0625in
C 7.5in
D 8.625in
E 4.375in "
and then DD 9500 series, "X-max with 8mm coil in gap - 29 mm each way"
both of these were copies and pasted from the website.
"XXX 12" Quad 1.2ohm VC Info Sheet
TS Parameters
Fs 34.4Hz
Re 1.17 ohms
Qms 5.19
Qes 0.49
Qts 0.45
Vas 31.6 liters
Sd 480 cm^2
RMS 1600w
Xmax 38mm //content.invisioncic.com/y282845/emoticons/eek.gif.771b7a90cf45cabdc554ff1121c21c4a.gif
Dimensions
A 12.5in
B 11.0625in
C 7.5in
D 8.625in
E 4.375in "
and then DD 9500 series, "X-max with 8mm coil in gap - 29 mm each way"
both of these were copies and pasted from the website.
