Reply to thread

Message

<blockquote data-quote="Big-Cat" data-source="post: 39240" data-attributes="member: 541469">I was just looking at the RE XXX, and i clicked on the T/S Parameters.&nbsp; I don&#039;t know much about this stuff, but i think the Xmax is how far the sub cone thing moves up and down, and the measurement is each way, right?&nbsp; and if i&#039;m correct, the more air that&#039;s moved from the cone moving more, the more bass is put out?&quot;XXX&nbsp; 12&quot; Quad 1.2ohm VC Info SheetTS ParametersFs 34.4HzRe 1.17 ohmsQms 5.19Qes 0.49Qts 0.45Vas 31.6 litersSd 480 cm^2RMS 1600wXmax 38mm //content.invisioncic.com/y282845/emoticons/eek.gif.771b7a90cf45cabdc554ff1121c21c4a.gifDimensionsA 12.5inB 11.0625inC 7.5inD 8.625inE 4.375in &quot;and then DD 9500 series, &quot;X-max with 8mm coil in gap - 29 mm each way&quot;both of these were copies and pasted from the website.</blockquote>

[QUOTE="Big-Cat, post: 39240, member: 541469"] I was just looking at the RE XXX, and i clicked on the T/S Parameters. I don't know much about this stuff, but i think the Xmax is how far the sub cone thing moves up and down, and the measurement is each way, right? and if i'm correct, the more air that's moved from the cone moving more, the more bass is put out? "XXX 12" Quad 1.2ohm VC Info Sheet TS Parameters Fs 34.4Hz Re 1.17 ohms Qms 5.19 Qes 0.49 Qts 0.45 Vas 31.6 liters Sd 480 cm^2 RMS 1600w Xmax 38mm [IMG]//content.invisioncic.com/y282845/emoticons/eek.gif.771b7a90cf45cabdc554ff1121c21c4a.gif[/IMG] Dimensions A 12.5in B 11.0625in C 7.5in D 8.625in E 4.375in " and then DD 9500 series, "X-max with 8mm coil in gap - 29 mm each way" both of these were copies and pasted from the website. [/QUOTE]

Verification