crossfire vr2000d wiring

[tsupra98 10+ year member]

ok so the vr2000d has two poss outputs and two neg outputs. and i've been told it's one channel on the inside. so that being said i'm wiring my two L7's which are both d2 voice coils to two ohms. right now i have it wired like you'd see off most charts. but if i wire the subs one at a time to where it's 4 ohms and connect one sub to one set of poss and neg and do the exact same to the other will the amp read 2 ohms inside?

i hope i worded that right and help would sure be appreciated

Click to read more...

 

[tsupra98 10+ year member]

sorry for the quick bump but looking for quick help so i can finish this

 

[daytonahemi 10+ year member]

yes

 

[tsupra98 10+ year member]

also does it make a big difference if one subs wires are longer then the other subs?

 

[tsupra98 10+ year member]

bump

 

[tsupra98 10+ year member]

can i get any help here?

 

[tsupra98 10+ year member]

so no one can help me here????

 

[NightDrifter05 10+ year member]

No one sub's wires being longer wont make a difference

 

[Louisiana_CRX 5,000+ posts]

a little bit longer on the wire don't matter

 

[bigaudiofanatic 10+ year member]

dosent matter

 

[Louisiana_CRX 5,000+ posts]

as far as the pos and neg speaker outputs on the amp...you can use both or just one set...its all the same...just don't accidentally use ++ or - - together going to the speaker...or you'll have probs...

 

[tsupra98 10+ year member]

as far as the pos and neg speaker outputs on the amp...you can use both or just one set...its all the same...just don't accidentally use ++ or - - together going to the speaker...or you'll have probs...

ok so if i do it that way the amp will still get a 2 ohm load?