Could ****** be going?

[FineLinePimpin 10+ year member]

yeah it could be the input and output speed sensors...part numbers 4800879 and 4800878...they are know for going bad...one is coarse thread one is fine thread....just replace both. They are like 20 bucks each...oh and those are chrysler OEM numbers

 

[btnhfan 5,000+ posts]

Its a 92.

Its the v6 3.0l.

Well I know the car is worthless, but i have put so much time into it for audio sh!t.

 

[jdawg 5,000+ posts]

which ***** a604 (4spd) or a a413 (3spd)? Does it shift at all? Is it stuck in 2nd (limp mode) ? If so may just need a TCM (this is 4spd only, the 3spd didnt have any electronics). See if you can pull codes by doing the key on/off cycle, then counting the flashes of the check engine light. Better yet would be doing it with a scanner, if you dont have one then get Auto Zone to pull the codes for ya.

 

[ace_800 5,000+ posts]

NVM, thought it was a manual

 

[jdawg 5,000+ posts]

Clutch maybe? My blazer I had a few years ago I had to mash the clutch in to get it in gear, right before it went out. ****** was good though.

auto's dont have clutch's

 

[Flipx99 5,000+ posts]

auto's dont have clutch's

Not ones that you touch anyway.

 

[ace_800 5,000+ posts]

Ya, realized that after I posted. //content.invisioncic.com/y282845/emoticons/escape.gif.52b661afb17bde1db0e0c7da97e75b38.gif//content.invisioncic.com/y282845/emoticons/banghead.gif.8606515f668c74f6de0281deb475b6fd.gif

 

[btnhfan 5,000+ posts]

Well the dash guages dont work so well.

So many burps = rattled grounds loose in the dashboard lol.

Like 1 out of 4 times I turn the van on, the speedometer works.

Ill check tonight and see what ***** I have. Im pretty sure its a 4 speed though.

 

[btnhfan 5,000+ posts]

Yea its a 4 speed.

 

[jdawg 5,000+ posts]

pull your codes, may just be a sensor problem. Does your entire insturment cluster not work? or just the speedo?

 

[btnhfan 5,000+ posts]

Well I guess that they work, its just that it doesnt light up ever. And the information center above doesnt work either.

 

[jdawg 5,000+ posts]

Heh, they may or may not be related. Gauges not working could be a circuit board problem, or the big plug that plugs into the back of it may be fuxored. As far as the *****, yea your gonna have to take it somewhere and get them to pull codes, not sure if Auto Zone can do it or not.

 

[btnhfan 5,000+ posts]

Yea well the dash lights have been out for a while now, the ****** problems only recently, so I don't think they are related. From about a year ago they would go on sometimes, then more burps in the van and they dont come on anymore.

 

[Polecat 5,000+ posts]

Lots of your seem like you know nothing about what you speak of. Just cause a ****** goes doesnt mean your motor is next to go...

hmmmmmmm:up2somet:

 

[davizzel 10+ year member]

might wanna check you ***** oil also could be a solenoid gone bad? get it checked as soon as possible the more you drive it the more damage you could be inflicting on it sometimes people dont even realize they dont have any ***** oil and end up making things worse by the simplest things take it to a ***** place theyll give it a test drive and usually its free //content.invisioncic.com/y282845/emoticons/santa.gif.e1ec9cf2e0a0dd232ad35aa594a126d0.gif