Complicated wiring,

[maseyferguson05 10+ year member]

I have a 2 channel MTX amp and a alpine 1000.1 amp, its only 2 ohm stable. Would it be possible to run both to a pair of 4 ohm DVC subs?

Click to read more...

 

[maseyferguson05 10+ year member]

Would i need to daisy chain them together or run another rca(i only have one rca on my HU) Or could i split the rca?

 

[thorshammer1 10+ year member]

Run one to ea sub individually and put them in thier own box. LOL

 

[I Like Waffle]

Yea just put diodes in the pos and neg of each amp and wire them together. Itll divide the ohm load between the 2 and youll be good to go //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif Did you figure out why your stereo wasnt working since you took the radio out yet?

 

[maseyferguson05 10+ year member]

Yea just put diodes in the pos and neg of each amp and wire them together. Itll divide the ohm load between the 2 and youll be good to go //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif Did you figure out why your stereo wasnt working since you took the radio out yet?

Yeah man, the antenna hookup was so far into the dash it took 3 of my buddys to finally get it in. They don't give you any room back there and the wire was about 5 inches too short.

Would i have to daisy chain the amps? Or run another wire from the battery? No, thats not right... I need a wiring diagram.