I been out of the hobby for about 6 years. Cars , audio and fabrication were hobbies of mine since high school, until i became an installer at circuit city and that kinda ****** the fun out of the audio part,that and debt,and spending years paying off said debt.
This build was birthed after sitting in my wife car one day and noticing just how lack luster the factory system was. And remembering the promise made to here years ago when we were dating that i would build a set-up for her.
I start cleaning out her trunk to find two boxes of subs ...red and black with DAT plastered all over them. i open the box to find lighting audio 10" p3's... apparently someone gave them to her years ago. i figure its a start.
i molded the subs in winisd and came up with a 3^ft tuned to 35 ,i decide to just build two of them since our trunks are the same dimensions.
I had home depot do the cuts since i don't have a table saw as of yet. (yes they fucked up all of them)
The wifes
Mine ,i decided to make mine a bit smaller due to my smaller trunk opening and shorter trunk.
2^ft tuned to 35Hz funny thing is due to the larger port i only saved 3" in depth on the outer dimensions
My patent pending custom hole jig for my router.
p3 in my wife enclosure,they sound pretty **** good ,very surprised.
MTX 10" 4500 (t4510-04) i went with thees because i had one sitting around that i bought with my circuit city discount ,but i never got around to using it. so i picked up another one on ebay...not to happy with them, very peaky and now low end. but they do get pretty loud.
This build was birthed after sitting in my wife car one day and noticing just how lack luster the factory system was. And remembering the promise made to here years ago when we were dating that i would build a set-up for her.
I start cleaning out her trunk to find two boxes of subs ...red and black with DAT plastered all over them. i open the box to find lighting audio 10" p3's... apparently someone gave them to her years ago. i figure its a start.
i molded the subs in winisd and came up with a 3^ft tuned to 35 ,i decide to just build two of them since our trunks are the same dimensions.
I had home depot do the cuts since i don't have a table saw as of yet. (yes they fucked up all of them)
The wifes
Mine ,i decided to make mine a bit smaller due to my smaller trunk opening and shorter trunk.
2^ft tuned to 35Hz funny thing is due to the larger port i only saved 3" in depth on the outer dimensions
My patent pending custom hole jig for my router.
p3 in my wife enclosure,they sound pretty **** good ,very surprised.
MTX 10" 4500 (t4510-04) i went with thees because i had one sitting around that i bought with my circuit city discount ,but i never got around to using it. so i picked up another one on ebay...not to happy with them, very peaky and now low end. but they do get pretty loud.