can power wire be used as ground?

no power wire runs in one direction only, and ground only runs to ground :p

and ground should be green, since that represents earth.

black wire should be power, since black = death.

 
no power wire runs in one direction only, and ground only runs to ground :p
and ground should be green, since that represents earth.

black wire should be power, since black = death.
You're talking about housing / building wiring codes.

12vdc systems use black as ground and red as B+

 
Your challenge my colors but not my one directional wire? :p
i was messin around.
Everyone knows wire is unidirectional... I thought that was a given //content.invisioncic.com/y282845/emoticons/confused.gif.e820e0216602db4765798ac39d28caa9.gif

 
You're talking about housing / building wiring codes.
12vdc systems use black as ground and red as B+
Housing code can be black or red for 'hot' and white or grey for 'neutral'. Don't want anyone grabbing a red thinking it's ok //content.invisioncic.com/y282845/emoticons/wink.gif.608e3ea05f1a9f98611af0861652f8fb.gif

 
//content.invisioncic.com/y282845/emoticons/thankyou.gif.5451126d09e870f796f50c3a4dd5acd7.gif

You're talking about housing / building wiring codes.
12vdc systems use black as ground and red as B+
//content.invisioncic.com/y282845/emoticons/thankyou.gif.5451126d09e870f796f50c3a4dd5acd7.gif
 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

I think you will be just fine to be honest. Id run it and check it after hammering on it quite a bit and check the temp on the wire by hand to see...
2
1K
So u know the individual slots on the ISO connectors and where they go? 12 volt red is accessories. etc. Red wire goes to the amplifier...
8
1K
Oh, total opposite. i play with storage bins full of wire scraps from past installs for fun. I hoard decent grade wires from audio homies...
6
1K
If you have multiple amps you do not need to run a power wire from each amp to battery.. You can have a single run of wire with a distribution...
1
1K

About this thread

bsean63

10+ year member
Undead Revolution
Thread starter
bsean63
Joined
Location
ohio
Start date
Participants
Who Replied
Replies
13
Views
2,066
Last reply date
Last reply from
TrIgZ
Screenshot 2024-05-31 182935.png

Doxquzme

    Jun 15, 2024
  • 0
  • 0
Screenshot 2024-05-31 182324.png

Doxquzme

    Jun 15, 2024
  • 0
  • 0

New threads

Top