Can i hook multiple amps to two subs

[Bass so loud it HZ]

Ok i just ordered to 18 inch subs i have two jp23s strapped and they need more power then that .i ordered 2 2ohmdvc subs .i prolly should have ordered the 1 ohm and ran it at half ohm but my question is i have 2 other jp23s could i wire 2 strapped to one sub and 2 strapped to the other sub .they are both going to be in the same box ..TIA

Click to read more...

 

[dragon.breath 10+ year member]

You can do it. You would have to wire each sub in series and wire it at 4 ohms.

 

[Bass so loud it HZ]

You can do it. You would have to wire each sub in series and wire it at 4 ohms.

Ok thanks.i was thinking 1 ohm apc so i could run the amps at half ohm apc .thats the only reason i got the 2ohm so i could wire down to half ohm .the plans are to get one big amp thats half ohm stable eventually

 

[dragon.breath 10+ year member]

I would advise against that. In my experience, wiring strapped amplifiers below rated impedance is a bad idea for daily.
I would strap 2 of the amplifiers to the subs at 2 ohms and throw the other two on eBay or facebook marketplace. A Taramps MD8000 2 ohm is $469 on Amazon. Selling 2 of the JP23’s would get you close.

 

[Bass so loud it HZ]

I would advise against that. In my experience, wiring strapped amplifiers below rated impedance is a bad idea for daily.
I would strap 2 of the amplifiers to the subs at 2 ohms and throw the other two on eBay or facebook marketplace. A Taramps MD8000 2 ohm is $469 on Amazon. Selling 2 of the JP23’s would get you close.

Ok ill just do the two ohm for now .i have really good electrical .ill prolly just go ahead and buy a bass 8 or 12 k for now until i can get a salt or crescensdo .ik alot of ppl running them at half ohm and if i blow it owell its cheap .appreciatte it