Bridging channels. How do I get both channels to output the same power?

[JeffM 10+ year member]

So I have a 4 channel amp that I'm going bridge so I can power a set of components. However, When I bridged the channels, one speaker was always louder then the other, and I can never get them to put out the same power. I was just wondering what everyone else does to get the bridged channels to output the same amount of power.

Click to read more...

 

[Immacomputer 10+ year member]

Did you play with each channels' gain? Is there equal signals on all 4 RCA jacks?

 

[fredridge 10+ year member]

is one speaker closer to you than the other? maybe with more power it becomes more noticeable

 

[JeffM 10+ year member]

Did you play with each channels' gain? Is there equal signals on all 4 RCA jacks?

Yes I tried adjusting the gain but it either becomes too loud or not loud enough. I cant get it just right.

Im not sure what you mean by them having equal signal, but Im assuming they do, I don't see why they wouldn't.