OP
pre98zetec 10+ year member
Member
- Thread Starter
- #16
Same screw's I used. I might have drilled it took close to the edge and that's why it cracked.
box build for a friend
- Thread starter pre98zetec
- Start date
- Replies 17
- Views 2K
-
9Participant count
-
Participant list
pre98zetec
Injected54 10+ year member
CarAudio.com Veteran
Looks good for your first box.
bigbangtheory 5,000+ posts
CarAudio.com Veteran
Better than I could ever do.
Activity
No one is currently typing a reply...
Similar threads
I think you're gonna have to get good with fiberglass or something, or find someone with a 3d laser scanner that can 3d print or mold you some...
- Started by evanp
- Enclosure Design & Construction
The tricky bit is that they're soft and floppy and they may be stretched a tad to go over the frames. I've used them in the past and come out...
- Started by Bass so loud it HZ
- Enclosure Design & Construction
In order to answer your question, I would need to know what model (e.g. SW4200, SW7524DVC). Also, are you looking to make a ported box or sealed?
- Started by Dewan
- Enclosure Design & Construction
Thanks everyone for the feedback. I got scared of the 4th being to much for a newbie but did end up building a box to 2.1 Cubic Foot tuned to...
- Started by c9obr6a
- Enclosure Design & Construction
Love this sub, hate AB's site, short on info for sure. American Bass XR-10D2 box recomend:
If you want to tune a 2.75 Cu Ft box (for two of these...
- Started by Mudflap
- General Car Audio
About this thread
- Start date
- Participants
- Who Replied
- Replies
- 17
- Views
- 1,954
- Last reply date
- Last reply from
- bigbangtheory
Latest topics
-
-
-
OFC vs CCA for wiring amp to car and for speaker use . . .
- Started by kanihoncho
- Replies: 2
-
Suggestions on 6 channel amp/powering 3 way active front stage and driver selection.- Started by JoeMama541
- Replies: 3
-
suggestion of which Butyl Automotive Sound Deadener Mat?
- Started by slater
- Replies: 8