Better Choice?

[TC2k15x2 10+ year member]

Choice-1

Run 2 TC-2000 15's sealed, at one ohm on a cadence zrs-10 (2500 watts rms) in a small sealed enclosure?

Choice-2

Run one really high end 15 such as the fully loaded BTL, DVC 2ohm wired to 1 ohm in a really spacious ported enclosure.

If choice 2 suggest some drivers id might want to take a look at.

Click to read more...

 

[btdickey99 5,000+ posts]

#2....other choices hdc3.....re mt....mach5 spl......yada yada

 

[RidnClean 5,000+ posts]

choice 2

 

[revrider1 5,000+ posts]

Choice 1 for me

 

[TC2k15x2 10+ year member]

Choice 1 for me

Any specific reason?

 

[TC2k15x2 10+ year member]

#2....other choices hdc3.....re mt....mach5 spl......yada yada

True thanks for the suggestions, I need a 15 that will be able to handle 2500 watts rms daily. Will these fit that description?

 

[btdickey99 5,000+ posts]

I personally would o with the hdc3....mainly bc of howmuch you save between that and a btl(esp if you mainly wanna go brand new)...althought the btl has the ability to get louder(as been argued in official hdc vs. btl thread) for the money you really cant beat an hdc3....

I also think for a SPL sub that it has great SQ

 

[TC2k15x2 10+ year member]

I personally would o with the hdc3....mainly bc of howmuch you save between that and a btl(esp if you mainly wanna go brand new)...althought the btl has the ability to get louder(as been argued in official hdc vs. btl thread) for the money you really cant beat an hdc3....
I also think for a SPL sub that it has great SQ

Yea I was looking at vids of them on youtube look like a nice sub.

 

[pawn man 10+ year member]

if you blow the tc good luck getting a rebuild kit for it.

 

[audioholic 5,000+ posts]

With 2500 watts for a single driver, I start getting concerned about power compression. Two subs would likely be able to utilize that much power more efficiently. But Im not gonna recommend TC drivers.