Audioque or AudioPipe?

If money isn't an issue the AQ is a more well built amplifier, however if you are running a 2ohm nominal load, you won't be pushing the amplifier that hard anyways, and the Audiopipe will do just fine. On the other hand, if you were going to try dropping to 1/2 ohm nominal, then the audiopipe would be a poor choice.

 
If money isn't an issue the AQ is a more well built amplifier, however if you are running a 2ohm nominal load, you won't be pushing the amplifier that hard anyways, and the Audiopipe will do just fine. On the other hand, if you were going to try dropping to 1/2 ohm nominal, then the audiopipe would be a poor choice.
The AP 3k is only 2 ohms stable, it's basically 2 amps strapped together.

 
bigger audiopipe amps do rated but barely and not always with a very clean signal, audioque delivers over rated clean power and better made. just get an aq2200 and be done with it, you will be pleased.
to be fair the OP said he only needed 2000 @ 2

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

Dirtrider4eva

10+ year member
√\_The CaUsE__
Thread starter
Dirtrider4eva
Joined
Location
Milwaukee, WI
Start date
Participants
Who Replied
Replies
51
Views
4,712
Last reply date
Last reply from
Dirtrider4eva
20260423_214720.jpg

BP1Fanatic

    May 14, 2026
  • 0
  • 0
20260419_124349.jpg

BP1Fanatic

    May 14, 2026
  • 0
  • 0

New threads

Top