AQ2200d

[dbhittin 5,000+ posts]

 

[vehementSPL 10+ year member]

Just an update, Installed and tested these. I am very happy to say the least. First test was in car with a 1ohm load at 13.2 volts and I was able to get 53.2 volts on the output before the dummy clip light came on. That is a little over 2800 watts. In a side by side test my MMats 2200.1 does a little over 2500 at 13.2 volts. So in the real world if you can get close to a 1ohm load you will see the rated power and then some. Now for the fun part, strapped the pair to my 2 DD9515's and they are amazing. There is things moving in my truck that were not meant to move like that. I now have some sick roof flex my rear view mirror is history. Ran the truck at a local comp and the setup did a 147.9 with little to no tuning, not a bad baseline in a full size Tahoe with no sound deadening. I just ordered another pair of these 2200's feed these stiff *** power hungry DD's , that should really bring them alive. //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

Now not to be rude. But you did use a clamp on and a volt meter correct? And you are saying 1 ohm after imp rise? If not this test is completely pointless . If it is a WIRED 1 ohm say.... guess... after imp. rise depending on the freq 1.5 ohm. so 53 volts for 1.5 ohm would equal about 35 amps . So 1855 watts RMS at 1.5 ohm. Pretty decent. But that is only if you are talking about a 1 ohm wired test and these are only approx

 

[Jeremiah25 10+ year member]

has anyone clamped this thing yet?

http://www.caraudio.com/forum/showthread.php?t=301099

 

[vehementSPL 10+ year member]

http://www.caraudio.com/forum/showthread.php?t=301099

Much better. did ya clamp it for a test closer to 1 ohm after imp rise

 

[Jeremiah25 10+ year member]

Much better. did ya clamp it for a test closer to 1 ohm after imp rise

Not yet. I will as soon as I get around to putting my old 4 12 box back in. I've been really busy lately, so I have been putting it off.

 

[Goindef154 5,000+ posts]

That amp is sexy

 

[dleccord 5,000+ posts]

no doubt. the design look a hell lot better than the white stamp on it.

 

[Symon_say 10+ year member]

This is mine, and something i notice is that my box have AQ1200D and AQ1600D on it, so matbe there will be a 1600 version soon.

 

[DBDRAGGUY 10+ year member]

Now not to be rude. But you did use a clamp on and a volt meter correct? And you are saying 1 ohm after imp rise? If not this test is completely pointless . If it is a WIRED 1 ohm say.... guess... after imp. rise depending on the freq 1.5 ohm. so 53 volts for 1.5 ohm would equal about 35 amps . So 1855 watts RMS at 1.5 ohm. Pretty decent. But that is only if you are talking about a 1 ohm wired test and these are only approx

I have clamped these strapped.

Resting load 0.6 ohms

72.4 volts

47.2 amps

3417 watts @1.53 ohms.

Feed Voltage 13.2 volts.