Amplifier / Protect / LC2i

[Sindrer2007]

Hi guys !

I have installed an LC2i , SPL monoblock and one 8" Ground Zero subwoofer in my 2016 VW transporter Van.

Run into som probelms during testing the Amplifier. It goes in Protect everytime i connect the Remote from LC2i. There are no speakerwires og RCA's connected. Only 12+ , Ground and the Remote.

The LC2i seems to work fine and the power light shows when i start the headunit. Connected the front speakerwires on both sides +\- +\- . 4 speaker wires into the Line out converter.

Any ideas on what the fault can be ?

Regards

Click to read more...

 

[C1500martin 10+ year member]

Factory impedance is to low or the output wattage is to high (but i doubt its the wattage)

 

[LosIsATool 5,000+ posts]

Sounds like the amp is shot

 

[Sindrer2007]

I will try too measure the voltage, Ground to Remote on amplifier?

I took the SPL amplifier out and replaced it with a kicker 2ch. Same problem ...