amp tuning? subsonic???

  • 3
    Participant count
  • Participant list
Subsonic keeps freq levels that are too low from getting to your subs, generally with ported boxes its nice to set the subsonic 10 hz under whatever your box is tuned to, so since your tuned to 38hz, set the subsonic to 28hz. by crossover do you mean High pass, i would set it at anything between 60 and 80, it dependz on where your mids are crossed.

 
set the lowpass o the amp around 80hz...make sure its a clean signal going to the amp...DON'T USE DECK OR EXTERNAL CROSSOVERS BEFORE THE AMP........OR YOU WILL SCREW UP THE SLOPES
is it teh lowpass, i get them conufsed lulz. but he is right.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Thank you, I did check the ground and and fuse holder wires and everthing is fine. All I did was swap amps and the previous Alpine pdx sounded...
2
92
Subs play to the beat with gain low but if I turn it up my subs play loud unwanted never ending bass that is constant and wont stop until I turn...
0
72

About this thread

memphis_vette

10+ year member
CarAudio.com Elite
Thread starter
memphis_vette
Joined
Location
Redding, CA
Start date
Participants
Who Replied
Replies
11
Views
8,655
Last reply date
Last reply from
Johnny Law.Lulz
24 civic.jpg

Popwarhomie

    Jun 12, 2024
  • 0
  • 0
Screenshot_20240611-211145.png

Blackout67

    Jun 11, 2024
  • 0
  • 0

New threads

Top