Amp Troubleshoot

  • 1
    Participant count
  • Participant list

Adrasys
10+ year member

Junior Member
I currently own a MTX 3401 (600W) mono block hooked up to 2 MTX 4500 (600 RMS)thunder subs in a side ported enclosure. I purchased an AudioQ 4 channel amp, and hooked it up, neither amp will turn on, i disconnected the 4channel completely and restored my setup to pre 4channel, and now my MTX will not turn on, all connections are good and secure, i have the same ground i started with and i ran a new Remote power line. All fuses are good, the 2 in each amp and the one by the battery. I'm out of ideas. Any thoughts?

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Getting a good voltage reading does not mean good power transfer. You could read 13.8v out of a 24 AWG wire. Recheck your amplifier's ground and...
2
203
No need to bypass the amp. Most use an LOC that takes the full amped signal and turns it into a flat RCA level signal. Here is the newest I have...
2
406
It would also be easy to add an equalizer to have individual rca inputs for all of the channels. A decent one can be had for less than $40...
6
491
  • Locked
NVX MVPA1 Best tiny amp Installed a bunch, but have one pushing a sealed 12 @ 2ohm in my daily beater Can bump it all day long and barely gets...
4
784
Amp
This tested well on youtube - not familiar with the brand but it is a pretty standard china build house amplifier...
5
568

About this thread

Adrasys

10+ year member
Junior Member
Thread starter
Adrasys
Joined
Location
Philadelphia, Pennsylvania
Start date
Participants
Who Replied
Replies
0
Views
550
Last reply date
Last reply from
Adrasys
20240604_170857.jpg

metalheadjoe

    Jun 5, 2024
  • 0
  • 0
Screenshot_20240605_200209_Adobe Acrobat.jpg

Dylan27

    Jun 5, 2024
  • 0
  • 0

New threads

Top