amp to box wiring.....

[Brad09]

If i wired my subs like this (http://www.rockfordfosgate.com/rftech/wiringwizard/2_4ohmDVC_4ohm.gif) would i connect the positive to the left sub, negative to the right, and wire the remaining + and - connections together on my box? here is my illustration to describe it better. I am new to car audio but willing to read and learn! //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif My wiring is for 2 15" dvc 4 ohm lanzar max pros, and a kenwood kac-9102d amp 500w rms x1 @ 4ohm 850w rmsx1 @ 2ohm. if anyone has a better way to wire them, to maximize my amps power and use most of the subs power, please let me know.

Box Connections

- + -------------- - +

\ }

\ }

\ }

\ }

\ }

\ }

- ---------------- AMP------------------------ +

Click to read more...

 

[blackbonnie 5,000+ posts]

welcome to the site, if your amp is not 1 ohm stable then you wontget any more power out of your subs. just wire it just like the diagram, if you have (2) dvc 4 ohm subs. then where the positve and negative come out all the way to the left, that is what goes to your box terminals. then just put a positve and negative wire from your box terminals to your amp.

 

[Brad09]

so this diagram is the same wiring method, its just showing the set of box terminals being used rather than just a + and - ? http://www.crutchfield.com/learningcenter/car/subwoofers_wiring.html?suboptions=Mono%5F2%2D4ohm%2DDVC&amptype=mono