Amp that does 125x4 @ 4 ohms

I have a Old Soundstream edge 4220 i can go for $190 shipped. Its a little under rated.

# 4 X 110 RMS 4 Ohm

# 4 X 220 RMS 2 Ohm

# 2 X 440 RMS 4 Ohm Mono

# Fully regulated, MOSFET power supply

# PWM circuitry

# Bi-Linear in/out selectable crossovers (Hi/Full/Low)

# Continuously variable 12dB low-pass crossover (40Hz to 120Hz)

# Continuously variable 12dB high-pass crossover (150Hz to 1.5kHz)

# Variable 0 – 18dB subwoofer equalizer (40Hz-120Hz)

# Continuously variable phase alignment (0°-180°)

# Tri-guard amplifier protection

# Intelligent Distress indicator (IDI)

# Platinum RCA input and output

# OEM floating ground input

# Platinum 4 gauge power inputs

# 2-ohm stereo/4-ohm mono stable

# Tri-mode operation

# Damping Factor 200

# Optional REmote Bass Control (EGA-RM)

# 10Hz – 30 kHz frequency response

# >97dB S/N ratio

# >0.02% THD

# Dimensions 17.7" L X 2.2" H X 11" W

 
bananaflash.gif
 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

87linkin

10+ year member
CarAudio.com Elite
Thread starter
87linkin
Joined
Location
alabama
Start date
Participants
Who Replied
Replies
4
Views
2,124
Last reply date
Last reply from
godhatescivics
20260423_214720.jpg

BP1Fanatic

    May 14, 2026
  • 0
  • 0
20260419_124349.jpg

BP1Fanatic

    May 14, 2026
  • 0
  • 0

New threads

Top