Amp repair

  • 2
    Participant count
  • Participant list

UnderFire
10+ year member

CarAudio.com Veteran
I'm going to try and take on an amp repair or two of my own. I've got a JBL BP1200.1 that jumps in and out of protect mode, and a kicker kx600.4 that stays in protect mode and never powers up.

What would you guys need to know to diagnose the problems with the amps?

 
hard to say what could be wrong with them..... open them up and take some pics of the boards.....
I've got these 2 of the JBL, a whole board shot and a pic of the power / gnd inputs.

JWNAR.jpeg


6klFa.jpeg


 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Not all 3 have same issue. Was just giving an example of the issues Each one has its own issue Yes I did replace rca cables and swapped left and...
3
1K
No need to bypass the amp. Most use an LOC that takes the full amped signal and turns it into a flat RCA level signal. Here is the newest I have...
2
144
It would also be easy to add an equalizer to have individual rca inputs for all of the channels. A decent one can be had for less than $40...
6
374
  • Locked
NVX MVPA1 Best tiny amp Installed a bunch, but have one pushing a sealed 12 @ 2ohm in my daily beater Can bump it all day long and barely gets...
4
676
Amp
This tested well on youtube - not familiar with the brand but it is a pretty standard china build house amplifier...
5
488

About this thread

UnderFire

10+ year member
CarAudio.com Veteran
Thread starter
UnderFire
Joined
Location
Dayton, OR, 97114
Start date
Participants
Who Replied
Replies
2
Views
2,801
Last reply date
Last reply from
UnderFire
Buick Amp Connector.JPG

maylar

    Jun 2, 2024
  • 0
  • 0
1717274743729.png

Doxquzme

    Jun 1, 2024
  • 0
  • 0

New threads

Top