I'm working on designing my amp rack before I do my installation. I've come up with this after lots of thought and trying different desings. I modeled this in Autodesk Inventor because the semester is over and I have some free time before I start working full time again //content.invisioncic.com/y282845/emoticons/rolleyes.gif.c1fef805e9d1464d377451cd5bc18bfb.gif
Any comments? My distro block will be behind the center amp. I have enough room for running RCAs to the front. I have a ton of split loom for this, I want to make it look as nice as possible.
Will the angles on the amps be okay for heat dissipation? I figure it shouldn't matter too much, it's all open.
Ignore the sub box though. It is actually my HT sub so I don't want to carpet it. I'll paint it when I have time.
Any comments? My distro block will be behind the center amp. I have enough room for running RCAs to the front. I have a ton of split loom for this, I want to make it look as nice as possible.
Will the angles on the amps be okay for heat dissipation? I figure it shouldn't matter too much, it's all open.
Ignore the sub box though. It is actually my HT sub so I don't want to carpet it. I'll paint it when I have time.
