hello! today i baught a second hand cadence q4000 amp.i noticed that it only has hp full and lp switch. and not the usuall petentiometer to choose your own frequency.searching the internet couldnt find a manual. so how would i be aple to tune it with my sub amp and match the right frequencies?
-
3Participant count
-
Participant list
Activity
No one is currently typing a reply...
Similar threads
One or two, they are still subwoofer outs and are mono summed signals from both left and right. Even the 2 RCA subwoofer pre-outs on the 2nd one...
- Started by kanihoncho
- Speakers
Hell... Run It.. You will be ok @ that Ohm load(2.67). Just dont go below 2ohms and you will be fine. 2ohms is the lowest stability of that...
- Started by OnixxFred
- Amplifiers
If you do use speaker baffles.. I recommend the plastic ones rather than the foam ones, and drill a 1/4" hole at the bottom of it in the back for...
- Started by JohnPD
- Amplifiers
Haven't 100% landed on which one, but I am down to those two
- Started by Big_E
- Subwoofers
That makes sense. I took it apart today. It doesn't look too impressive but it should be better than the head unit. I'm going to install something...
- Started by 1995mirage
- General Car Audio
About this thread
New threads
-
-
Subwoofers popping when amplifier is turned off and onAll my speakers used to do this as of recent. Along with...
- Started by tonksie93
- Replies: 8
-
Help needed audio stops playingHey guys hope you are well I have a bt starsound single din...- Started by Thevaran Moodley
- Replies: 1
-
SubsWhich would be a louder sub? Audiopipe 4 stack or a sundown...- Started by Kevin Persaud
- Replies: 10
-
silly question butare there any new headunits out of the box that come with...- Started by eriknoi05
- Replies: 7