Amp popping fuses

[JRich89 10+ year member]

Wiring up 2 kicker CVR dvc 2 to a Lanzar Vibe 266. Wired the voice coils to 1 ohm the first time but realized we couldnt after the protection light came on and fuse blew. Before they blew it played fine until the gains cut up, then that is when it blew. Next day we fix the voice coils to 2 ohm but before the subs even come on the amp blows the right fuse. Is this a faulty amp or was it fried when ran at 1 ohm?

Click to read more...

 

[Bake 10+ year member]

Sounds like you may have toasted the amp. Unhook the subs and see if it will power up and stay on with nothing connected to the output.

 

[SBLAZER]

is the amp stable at 1ohm? check all ya wiring make sure wires arent touching and make sure that u are wiring them correctly

i jus noticed this, u have 2 dual 2s,lmao that doesnt wire to 1ohm, u wired the amp to .5ohm that might have been ya prob there, not the amps fault its user error like it always is.

 

[Mr. Opportunist 10+ year member]

is that amp .5ohm stable? im to lazy to go searching for the info on it...

 

[SBLAZER]

prob not do to the fact of wha happen