Amp needed 600w @ 4ohms ($200) low thd

[ALAMO695 10+ year member]

hey guys, im looking for a good amp to run 2 electro voice 10" speakers. These, yes i know they are Pa system, and not suppose to be ran on cars, etc. The thing is i am putting those on my car. Now if you guys would be kind enough to help me find a amp for them, they are 8ohm speakers so i will run them in parallel to drop it down to 4 ohm

basically what i need is

-a amp around 200 bucks (+-20 bucks)

-has to have filters/eq/controls to tune the amp since i am using stock radio

-low thd

-i need minimum 600watts when bridged at 4ohm

what would you recommend, and thanks a lot for reading and replying to my thread.

Click to read more...

 

[mast240 10+ year member]

what are you going to be powering? for that amount of money... and only needing 600w.... you have ALOT of options

 

[infamous_e46 5,000+ posts]

Treo Engineering SSX125.2 - AmpGuts.com

underrated //content.invisioncic.com/y282845/emoticons/fyi.gif.9f1f679348da7204ce960cfc74bca8e0.gif

one of these 220 shipped conus

 

[disturbed471985 5,000+ posts]

$77 plus shipping - http://www.caraudio.com/forums/amplifier-classifieds/509809-elemental-designs-nine-2-a.html

Rated to do 400@4 but thats at 12.5volts so in real life it does a good bit more. It is an A/B class amp though.

 

[ALAMO695 10+ year member]

what are you going to be powering? for that amount of money... and only needing 600w.... you have ALOT of options

well my system is going to consist of

a set of Rockfords power components 6.5 for the front

a set of Rockfords power components 6x9 for the rear

a fi btl 15 inch subwoofer in the trunk

a pair of electro voice dl10x wired in parallel (to drop to 4ohms)

the electro voice need 300wts rms each so i need a amp that will do at least 600watts rms at 4ohms

UOTE=eL_wEEnIe;7561366]Treo Engineering SSX125.2 - AmpGuts.com

underrated //content.invisioncic.com/y282845/emoticons/fyi.gif.9f1f679348da7204ce960cfc74bca8e0.gif

one of these 220 shipped conus

how much would these go for new ?

 

[Heeltoeclutch 10+ year member]

I have a mint Elemental Designs NINE.2x, rated at 600W @ 4 ohms at 12.5V bridged that I might be willing to sell. People on CACO have clamped it doing 750. 90A of fusing I believe? Probly 160+shipping.

edit: lulz just did a search and on the elemental designs forum someone clamped theirs at over 800 //content.invisioncic.com/y282845/emoticons/laugh.gif.48439b2acf2cfca21620f01e7f77d1e4.gif

 

[infamous_e46 5,000+ posts]

im not sure how much the treo went for new but i know it wasnt cheap or under 270

 

[disturbed471985 5,000+ posts]

im not sure how much the treo went for new but i know it wasnt cheap or under 270

It was a good bit over $300 but that was prob 2 years ago this may be a newer model though. They are some beastly amps.

 

[infamous_e46 5,000+ posts]

It was a good bit over $300 but that was prob 2 years ago this may be a newer model though. They are some beastly amps.

mine is the older model look at them guts and tell me it doesnt put a sundown 125.2 to shame

 

[disturbed471985 5,000+ posts]

Oh I know its does well over rated. Local dealer use to carry Treo and Kove and Treo makes nothing but pure quality if it says 125 I would expect a good 170-200 from it.

 

[mclerico83 5,000+ posts]

Cadence Z1200 2-Channel Class AB 1200 Watt Amplifier | eBay

.004 thd amazing amp and sq

US Acoustics USX800F made by ZED Audio | eBay

.01 percent old school yummy