Amp kit question

[Sir Smoke A Lot 10+ year member]

I have an Alpine PDX 4.150 and a PDX 1.1000 that I will be powering my system with. The 4.150 will be bridged to my components. Would this kit http://www.tsunamionline.com/product.php?id=533 be a good choice?

Click to read more...

 

[Snow90 10+ year member]

Are you looking to run both those amps of that kit? If so I would run 1/0 from battery to distro block in your trunk then run 4 gauge off a distro block to each of the amps.

 

[bigaudiofanatic 10+ year member]

That kit should work fine but if you want to go a little beefier go with 0 gauge but i dont recommend that you need it.

 

[Snow90 10+ year member]

why wouldn't you recommend that. Better safe than sorry.

 

[pentavolvo 10+ year member]

4ga would do it but IMO 0ga would be a bit better