Amp is on but no sound question

  • 6
    Participant count
  • Participant list
So I went out at lunch and the sound was working just fine....had the Dmm and tried to attempt what was said but I kept getting 0 on it (so probably did it wrong)...but as of now it is working...Lord knows if it will when I get off but I guess we'll see

 
So I went out at lunch and the sound was working just fine....had the Dmm and tried to attempt what was said but I kept getting 0 on it (so probably did it wrong)...but as of now it is working...Lord knows if it will when I get off but I guess we'll see
sounds like short or loose ground or remote wire make sure all wires are tight.. pull amp fuses sometimes they can get like 1/2 way burnt and will work sometimes and not work later..

 
well on my way home that same day the sound cut off again.....i actually got a new set of rcas and tried it and still no sound...the amp is on....what are the ways to check if the cd players rca outlets went bad because i've had taht happened once years ago, but i'm just really confused as to what is wrong still

 
u checked all fuses, ground and remote turn on where it's wired to up front? did u pull sub/s make sure wires are tight? if u have 2 subs unhook 1 see if other 1 works etc.. other that that stuff u need to try amp in another car or borrow 1 or get new hu, amp or hu can just die..

 
Everybody and everything loves them some Pac and 90's hardcore rap //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Update. Took line out back and just upgraded my head unit. Now my sound only plays when fade is in rear and balance to left. Ugh. One thing after...
20
3K
Check your remote line or RCA, some decks have written remote 2 times different wires one solid blue one blue and white, some do the misstake...
10
3K
Getting a good voltage reading does not mean good power transfer. You could read 13.8v out of a 24 AWG wire. Recheck your amplifier's ground and...
2
156
No need to bypass the amp. Most use an LOC that takes the full amped signal and turns it into a flat RCA level signal. Here is the newest I have...
2
352

About this thread

TupacThaDon1971

10+ year member
Senior VIP Member
Thread starter
TupacThaDon1971
Joined
Location
sandusky
Start date
Participants
Who Replied
Replies
22
Views
1,261
Last reply date
Last reply from
TupacThaDon1971
20240604_170857.jpg

metalheadjoe

    Jun 5, 2024
  • 0
  • 0
Screenshot_20240605_200209_Adobe Acrobat.jpg

Dylan27

    Jun 5, 2024
  • 0
  • 0

New threads

Top