Amp... 600-800WRMS @ 2 Ohms

[Alpine CDA-9815 10+ year member]

It's been awhile since I've been into the car audio thing. I've bought 2 ID8V.3-D2's. I'm going to first run them IB and see if I like that, if not I'll put them in a small sealed box.

I'm looking for an amp that's not too big. I've ran the Alpine MRD serious in my last set up.... thinking maybe an Alpine MRD-M605? Not looking to spend more than $300.

Click to read more...

 

[datboiroy]

pm sent

 

[bchandler 10+ year member]

Have you considered the Phoenix Gold Xenon 600.1? A very nice amp for a bit less than your budget.

 

[viscid240 10+ year member]

First thing that came to mind was--Kicker zx750.1.

 

[Turborusty 10+ year member]

How about an Excelon KAC-X1R?

Digital Mono MOS-FET power amplifierDie cast aluminum heatsink

K-STAT technology

Dual Sigma drive Technology

Variable LPF

Max Power:2400 watt

RMS: 600 watts x 1 @4 ohms

RMS: 1200 watts x 1 @2 ohms

RMS: over 1000 watts x 1 @1 ohm

1 ohm load stable

Signal to Noise ratio: 80 dBA

Low pass filters: 40-200Hz

Infrasonic filter:15 Hz-60Hz (Variable) -24dB/OCT

3-25 amp onboard fuses

Line output filter

Opitional remote bass boost port (Remote bass knob not included)

http://cgi.ebay.com/KENWOOD-EXCELON-KAC-X1R-DIGITAL-MONO-AMPLIFIER-1200W-07_W0QQitemZ250156858483QQihZ015QQcategoryZ64570QQssPageNameZWDVWQQrdZ1QQcmdZViewItem

Turborusty

 

[gijoe 10+ year member]

I just bought the phoenix gold 600.1 for my IDQ 10's. It hasn't arrived yet but I'll let you know how it sounds. To tell you the truth I hooked them up to my old amp and they sound great at only 100 watts a piece, I can't wait to hear them properly powered.