Aero Port Port Area Question!!!

  • 2
    Participant count
  • Participant list

DropDownLowYota
10+ year member

Senior VIP Member
I'm on the torres designing a box and I have a design with 1 common chamber non aeros with port at 91 inches tuned to 32.9. I just made a design which would be using 2 6" aeros tuned to 32.6, but the issue is that it shows the port area at 56 inches. Is it supposed to be like this? The difference is area is a lot. Would it matter if the port area was so much less with the aeros?

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Are you going to do actual aeroports with flares on both ends? I’m running a single 4 inch aeroport on my little 750 watt 12. It has flares on...
3
2K
And you failed to mention airspace of the box or the sub and power you were running. In 89 most subs were extremely low xmax meaning very little...
14
2K
Yeah, saw that too, was like ??? wtf! They do know there stuff, I usually just roll with it!
13
1K
You could try to make the port longer, but there might be other reasons with the box won't extend lower, or even the sub. You'd have to reverse...
3
875
While that program is pretty neat, it assumes you know the values. I was just recapping the numbers you provided. RS recommends the following...
4
1K

About this thread

DropDownLowYota

10+ year member
Senior VIP Member
Thread starter
DropDownLowYota
Joined
Location
Honolulu, Hawaii, United States
Start date
Participants
Who Replied
Replies
2
Views
1,035
Last reply date
Last reply from
DropDownLowYota
Screenshot 2024-05-31 182935.png

Doxquzme

    Jun 15, 2024
  • 0
  • 0
Screenshot 2024-05-31 182324.png

Doxquzme

    Jun 15, 2024
  • 0
  • 0

New threads

Top