A few vids of my new box! Built by dbeez.

Just a hint. Instead of leaving that nasty looking glue squeezing off the edge, when its still wet wipe it with a damp rag. This will remove all the drips and allow it to dry nicely.

 
I see you and raise you 1 //content.invisioncic.com/y282845/emoticons/tongue.gif.6130eb82179565f6db8d26d6001dcd24.gif

840a0526.jpg


Just finished mine last monday

Oh and the manual says 33hz //content.invisioncic.com/y282845/emoticons/wink.gif.608e3ea05f1a9f98611af0861652f8fb.gif

I dont think I have near that much panel flexing. What is your sub sonic filter set at?

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

I think he'sasking because electricity is often compared to water to make it easier to understand. It can be helpful, but it can be misleading...
8
1K
The bigger the gauge number, the smaller the wire. 8awg would be smaller than 7awg. Yeah, go with 4awg. 7awg sounds like it must be for an...
7
2K
I found this, can it be done with snapon modis ultra scanner which i have...
11
1K
https://www.youtube.com/@therealmatty_s/videos
0
510
Start by laying the larger bottom panel in an open space, then slowly “dry” assemble it by laying the pieces where they go like a puzzle. It...
1
38

About this thread

WashYourWinky

10+ year member
The Pilot
Thread starter
WashYourWinky
Joined
Location
Cincinnati, Ohio
Start date
Participants
Who Replied
Replies
19
Views
1,452
Last reply date
Last reply from
WashYourWinky
1000007975.jpg

Mr FaceCaser

    May 16, 2024
  • 0
  • 0
1000007974.jpg

Mr FaceCaser

    May 16, 2024
  • 0
  • 0

New threads

Top