.67 Ohm load, Should I do it?

[MrSplorDie 10+ year member]

Im debating on a new setup which would consist of 3 cadence svc 2 ohm subs which would be wired to .67 ohms running off a memphis 2500D... Would this work daily, Im counting on the box rise to help me out.

Click to read more...

 

[winkychevelle 10+ year member]

i wouldnt on that amp. iirc it has an ohm load protection curcuit which shuts the amp down on startup ohm load below 1ohm but if you have the electrical to back it up try it and if the amp shuts off or gets hot then dont do it

 

[MrSplorDie 10+ year member]

I got it from somebody im going to check and see if its been modded to were the circuit protection was taken off

 

[kr15 5,000+ posts]

I would think that amp will still do some nice power at 1.33

 

[Louisiana_CRX 5,000+ posts]

lulz..... i see magic smoke in someones future //content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif

 

[MrSplorDie 10+ year member]

I would think that amp will still do some nice power at 1.33

it does but the subs im getting are "SVC" //content.invisioncic.com/y282845/emoticons/frown.gif.a3531fa0534503350665a1e957861287.gif

 

[RAM_Designs 5,000+ posts]

Aren't those Mojo 2500D's only 2ohm stable, or am I losing it?

 

[MrSplorDie 10+ year member]

the first gen was 2 ohm stable i have the 1 ohm stable one, but I made up my mind and decided not to even try it //content.invisioncic.com/y282845/emoticons/wink.gif.608e3ea05f1a9f98611af0861652f8fb.gif

 

[kr15 5,000+ posts]

it does but the subs im getting are "SVC"

reading > me

 

[Wingman0121 10+ year member]

I would get 4 of those svc subs and run it at .5 ohm. The Memphis will run that low ONLY if you have strong electrical, meaning big 3, 200a+ alternator and three large batteries.