2008 Superduty Question about install.

[RC51]

Just picked up all the new equipment for my Superduty. Today I finished putting 100 SF of Dynomat between the four doors, made and installed the front plates with the QSD components and finished the box with four 10" Digital Audio's.

Tomorrow I'll be pulling the seats and carpet to put down the Dynomat on the floor and then I'll be installing the 5510 Eclipse NAV unit and the two Zapco amps. My question is in regard to the Sirius Sat. Radio from the factory. The truck has it with the factory head unit and the new Eclipse is Sirius Ready. So, can I use the factory Ford reciever with the Eclipse? If so, where is it located and how would I go about doing it?

If I can avoid buying the Sirius receiver that would be great. Any help would be great.

Thanks.

Click to read more...

 

[Worlddre 5,000+ posts]

unless you find some kind of interface which i strongly doubt exists no

 

[RC51]

Ok, thanks. I guess I was hoping for too much.

 

[ultimate157 5,000+ posts]

You can run a dual HU and take the output of the factory radio and put it into the aux in for the eclipse. Might be harder to do than its worth, but its possible.