2 issues, please help.

  • 1
    Participant count
  • Participant list

79elcamino

Junior Member
10
0
Brooklyn
My set up is alpine radio to eqx from eqx it goes to two 2xs and from the two 2xs it goes to three amps. One amp is sub, other amp is Midbass, and last amp is tweeters and midrange.

When I connect my rcas to my eqx and have the outputs from the eqx disconnected and play something very low music comes out from my tweeters and midrange speakers. It does change volume with the radio knob or gains on the eqx. Second issues, with the outputs disconnected there is no hiss from speakers when I connect the outputs I get a hiss,all gains at lowest setting. The hiss doesn't get louder or lower with any gains or radio volume knob. No rcas are ran next to the power wire from the battery but the rcas are all ran with each other,going from eqx to the 2xs then to the amps. The rcas are close to the power connection and wire going to the eqx.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

As for which signal to use, I tried all combinations and getting signal from the dash and front & rear doors is the only way the system sounded...
15
2K
Twist both grounds together. Good call on checking power with a multimeter. I assume you have pulled out and re-inserted the fuses, so as a quick...
1
663
Are your tweeters amplified or powered by the radio or maybe factory amp? I'd check your wiring for sure, make sure 12v power and ground are...
1
657

About this thread

79elcamino

Junior Member
Thread starter
79elcamino
Joined
Location
Brooklyn
Start date
Participants
Who Replied
Replies
0
Views
392
Last reply date
Last reply from
79elcamino
IMG_0692.jpg

just call me KeV

    May 1, 2024
  • 0
  • 0
IMG_0691.jpg

just call me KeV

    May 1, 2024
  • 0
  • 0

Latest topics

Top